5000 gallon water tanks

The Quick and Easy Way to Sanitize Your Water Tank

Ensuring your water tank is kept clean and free of bacteria and other contaminants is an important part of maintaining a healthy home environment. Luckily, with proper care and maintenance, it’s easy to keep your water tank clean. This guide will provide you with the tips and tricks you need to ensure your water tank stays safe and sanitary.

Gather Supplies and Turn Off the Water Pump

Before starting the cleaning process, it’s important to have the correct supplies on hand. Make sure you have a scrub brush, bleach or disinfectant, a small bucket and gloves. Once you’ve gathered your materials, turn off the water pump to prevent any leaking after cleaning. Then remove any water from the tank with a large container or buckets before starting to clean.

Clean the Tank

Begin with the cleaning process by scrubbing the water tank with a brush and a safe cleaner. Make sure to use a long-handled brush so you can reach all areas of the tank that need to be cleaned. Repeat this process several times and make sure to vacuum off any remaining dirt or debris after ready to rinse. After you’ve finished scrubbing, rinse out the tank thoroughly with clean water until all soap residue is gone.

Add Sanitizing Agents to the Water Tank

After the tank has been rinsed out, you’ll need to add a sanitizing agent. These agents can be chlorine bleach or a specific water tank sanitizer, both of which should be available at your local hardware store. 

Chlorine bleach is an effective but deadly chemical and needs to be used with caution. Follow the instructions on whatever product you use carefully. Once added to the water tank, allow it to circulate for at least 30 minutes before draining and then rinse off any residue with clean water.

Let it Sit for 24 Hours After Sanitizing It

After the sanitizing agents have been added and circulated for at least 30 minutes, you should let the tank sit for about 24 hours before filling it up. This will give the sanitizing agents time to fully saturate the tank and kill any remaining bacteria or viruses that may be present.

However, don’t leave it in the tank for more than 48 hours as this could corrode some of your parts. After 24-48 hours, check that all components have been properly sanitized and safe to use before filling up with fresh water.

Reactivate the Water Pump and Enjoy Cleaner Water!

All that’s left to do is reactivate the water pump and allow it to fill up the tank with fresh, clean water. During this process, monitor all your equipment for any irregularities or leaks. Once the tank is full, you can enjoy cleaner, safer water for drinking, washing dishes, bathing and more. Make sure to perform regular maintenance on your water tank system every few months to avoid any serious problems from arising.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *